Stamp9G45

warning: Creating default object from empty value in /homepages/38/d83367651/htdocs/armbedded.eu/drupal-6.38/modules/taxonomy/taxonomy.pages.inc on line 33.

Upgrade package to add NAND 4-bit BCH ECC support to Stamp9G45

Submitted by cglindkamp on Tue, 07/23/2013 - 15:01

Stamp9G45

Micron flashes used in Stamp9G45, for which this upgrade is highly recommended have the following FBGA codes written on them:
NQ279
NW193

Stamp9G45-BCH-upgrade.tar.bz2 (60.34 MB)

What is the expected lifetime of the product?

Last edited by mlanger on Tue, 06/04/2013 - 10:28

We will try to produce products as long as possible. This means, that there will be hardware revisions and changes of the used components if necessary. Of course, the most important factor for every product is the processor itself. Please find information about how long a certain processor is planned to be produced in the PDF attached below. In case of a processor hits its EOL, we try to offer a similar product with migration support for existing customers.

1 attachment

My board suddenly does not boot correctly or crashes.

Last edited by cglindkamp on Thu, 03/14/2013 - 16:20

The boot stops displaying ROMBOOT or halts in U-Boot.
The kernel crashes randomly.

If your board runs a bootstrap prior version 3.4 (bootstrap 3.4 prints version information, older versions do not), the problem should be solved by updating.

The new images can be found here:
http://www.armbedded.eu/node/629

Update procedure:
1) launch SAM-BA and choose board according to:
http://www.armbedded.eu/node/8
2) run NANDFLASH "Enable NAND flash" script
3) run from SAM-BA console: NANDFLASH::EraseBlocks 0 0x1ffff
4) run "Send Bootfile" script with the appropriate image for your board

For even newer Stamps also consider the following download: