Panel-Card Connector
Technical Reference
Copyright © 2010 taskit GmbH
All rights to this documentation and to the product(s) described herein are reserved by taskit GmbH.
This document was written with care, but errors cannot be excluded. Neither the company named above nor the seller assumes legal liability for mistakes, resulting operational errors or the consequences thereof. Trademarks, company names and product names may be protected by law. This document may not be reproduced, edited, copied or distributed in part or in whole without written permission.
Table of Contents
List of Figures
Table of Contents
The Panel-Card Connector was designed to serve the Panel-Card 57/70 as an evaluation platform and as a deployable base board for all Panel-Cards. It can also be used to develop and deploy Stamp9261 and Stamp9G20 systems.
The Panel-Card Connector makes it easy to put the Panel-Card/Stamp to use. The first steps involve the following:
connecting the board to the Panel-Card/Stamp-Adaptor according to Figure 1.1, “Panel-Card Connector setup”
connecting the wall adapter to the main supply and to the board
connecting RS232 IF-Module via the serial cable to a COM port of a PC
starting a terminal program for the selected COM port at 115200 baud, 8N1
starting the module by flipping the power switch
boot messages of the module are now expected to appear on the terminal
From an unregulated input voltage between 8 and 35V two voltages are produced:
3.3V for the CPU module
5V for USB
The following connectors are part of the Panel-Card Connector
Two 40-pin header connectors (0.1 inch pitch)
Ethernet 10/100 MBit
USB Host (dual)
USB Device
RS232 for use with an RS232 IF-Module
DC connector for power supply
The following circuit diagram is intended for reference only and does not dispense the user from checking and applying the appropriate standards. No warranty can be granted if parts of the circuit are used in customer applications.
